1/4" ID Plastic Brewing Tubing (Thin Wall) - Sold by the Foot

1/4 in. ID Plastic Brewing Tubing - Thin Wall

This 1/4 in. ID thin-wall plastic brewing tubing is sold by the foot for small transfer, filling, and equipment runs where that inside diameter is the correct fit. It is useful when you need a short custom length instead of a full coil of tubing.

Use it for compatible low-demand brewery tasks where the tubing, barb, clamp, and liquid path all match. Because tubing requirements vary by system, confirm the inside diameter and the intended use before ordering.

Best Uses

• Custom tubing lengths: order the number of feet needed for a replacement section or small setup.
• Compatible transfer paths: useful where 1/4 in. ID plastic tubing is the correct match for the fitting.
• Filling and utility lines: practical for simple beverage, sanitizer, or equipment jobs when conditions are appropriate.
• Spare line: keep a few feet around for quick replacement of stained, brittle, kinked, or hard-to-clean tubing.

Fit and Care Notes

Make sure the tubing seats fully on the barb or fitting without splitting, stretching too far, or slipping loose. Use clamps where your setup requires them and leak-check before moving beverage or cleaning solution through the line.

This listing does not verify pressure rating, gas-line use, high-temperature service, or draft-system compatibility. If the application requires a rated beverage line, gas line, draft line, or hot-side hose, choose tubing that matches those requirements. For related parts, browse our tubing and transfer equipment and plumbing fittings.